TachFix
TachFix tachometer adapter. This unit is designed to modify the rpm output from ECU's such as the megasquirt to work with rev counters that are designed to be used with a negative coil pulse. If you are converting from a distributor based ignition system to a wasted spark coil pack setup, you may need one of these to make your rev counter read! Simple to install, you just need an ignition live, ground and your existing tacho wiring, instructions are provided.
Cost: £35 including UK Postage. Cost £40 including Worldwide Postage.
Cost: £35 including UK Postage. Cost £40 including Worldwide Postage.
TachFix unit including UK Postage £35
KnockTek
The KnockTek knock sensor conditioner, designed by EXTRA EFi. This clever piece of hardware has two primary functions. Firstly it uses the output from a standard OEM two pin knock sensor (as fitted to most modern engines) to give a visual display of engine 'knock'. Secondly it produces an output signal that can be used as a direct input to ECU's such as the MS2 & MS3 to activate ignition system retard and stop the engine from being damaged. Invaluable as both a tuning tool and an injection system safeguard that could save your engine from detonating. These can be supplied with a sensor if required but are best suited to using the sensor fitted to your engine (or one designed for that engine if none is fitted). If you require a remote LED (for dash mounting) please request at time of order.
Cost: Single input £40 including UK postage
Twin input £45 including UK postage
Version 3.0 Now in stock !!
Cost: Single input £40 including UK postage
Twin input £45 including UK postage
Version 3.0 Now in stock !!
OUT Of STOCK UNTIL MARCH 2018
OUT Of STOCK UNTIL MARCH 2018
Megasquirt Wiring Looms - Built to Specification
I build finished wiring looms to meet the needs and demands of almost any Megasquirt installation. From a standard BMW 325i loom to convert to a distributor based Megasquirt 2, all the way through to a custom length 302 Ford engine with 16 injectors, twin turbos and a fully digital dashboard running MS3, if you know what you need and can supply measurements I can supply a loom to do the job. Prices vary according the number of cylinders and wiring complexity. Prices start from as little as £100, the most expensive I have produced so far was £400. If you would like further information or a quote please feel free to contact me by email or phone and I will do my best to help.